YONICO ROUTER BIT REVIEWS
This is our Yonico router bit review. We ordered three router bits med and a two larger bits. And as soon as they came in we started cutting. They were as cheap of a price as you can get. And we where hoping they would be a good bit. With the high price of router bits these days. It would be nice save a little money.
JEWELRY BOX SIDE #18134
The first thing I saw when open the package was the bearing on top was bad and could not be used. Not a problem I will be using the fence for this bit, so I removed the bearing. Once installed and the fence set , I turned on the router. The vibration was very bad, tried different speeds and nothing help. I tried it anyway, after the third pass the chatter was bad and the piece was scrap. Other than the bearing being bad I saw no defect that would cause this much vibration, just a bad bit. I would not recommend the larger bits at all.
23/32 RADIUS CONVEX # 13102 /JEWELRY BOX FOOT # 18135
After inspecting the bearing and seen all was OK I set up and start cutting. Both bits cut good not as smooth as some of the name brands but workable . Had a little clean up on the pieces I cut but not to bad. Very little vibration. If your on a budget you can get by with the smaller bits, just make sure you inspect the bearings before use.
LARGE FURNITURE FOOT MOLDING #18136
After inspecting the bearing and seen that it was good, I set up and started to cut. Had some vibration but not as bad as the jewelry box side bit after three passes the work piece had a lot of chatter but still usable after some clean up. Not as good as I was hoping for. For now I think I will stay away from the larger bits, they are to hard to work with.